Secure Cover - Philips CM-150 CA Manual

Secure Cover

(Surface Mount only)
Once you have finished connecting all data and power inputs and outputs, secure the
CM-150 CA cover.
1. Seat the cover on the CM-150 CA housing.
2. Using the included 3 mm hex wrench, tighten the housing cover's six captured
screws, as indicated in the diagram to the left. Torque each screw to
approximately 1.8 Nm (16 in-lb).
3. Tighten the cable glands around all cables. Do not overtighten.
4. For wet or damp locations, seal all points of entry to prevent water infiltration.
Use RTV silicone to seal screw holes and cable glands.
Configuring CM-150 CA with QuickPlay Pro
(Optional)
You can configure CM-150 CA devices using QuickPlay Pro addressing and
configuration software. In Ethernet installations, you can automatically discover
all CM-150 CA devices using QuickPlay Pro with a computer connected to your
lighting network.
When a CM-150 CA device is connected to your lighting network, the CM-150 CA
tab under PDS Configuration becomes active.
16
CM-150 CA Product Guide
You can download QuickPlay Pro from
E
www.colorkinetics.com/support/addressing/.
For details on standard QuickPlay
E
Pro options for CM-150 CA, refer to the
Addressing and Configuration Guide,
which you can view or download at www.
colorkinetics.com/support/addressing/.