Philips CM-150 CA Manual page 10

Inspect CM-150 CA and Accessories
Carefully inspect the box containing CM-150 CA and the contents for any damage that
may have occurred in transit.
We recommend that you ensure your CM-150 CA devices are running the latest
version of the firmware, and update the firmware if necessary, before positioning and
mounting the devices. See www.colorkinetics.com/support/downloads/firmware/ for
complete information.
Position and Mount CM-150 CA
Make sure the power is OFF before mounting and connecting CM-150 CA.
1. Each CM-150 CA is identified by a unique serial number and IP address. The
serial number and default IP addresses are located on a label on the CM-150 CA
housing. If your installation requires multiple CM-150 CA devices, record the
IP addresses (Ethernet) in a layout grid (typically a spreadsheet or list) for
easy reference.
2. Assign each device to a position in the lighting design plan.
3. Position each CM-150 CA in its designated mounting location, as detailed below.
Surface Mount Installation
Make sure the mounting surface is flat, suitable for the mounting hardware, and clear
of debris and other obstructions.
The overall dimensions of each CM-150 CA, Surface Mount device are 208 mm
(8.2 in) wide x 90 mm (3.5 in) deep x 39 mm (1.5 in) high. Make sure the mounting
location allows enough space for air to move freely around the device. Be careful not
to obstruct or submerge the vent on the CM-150 CA housing.
Use four suitable mounting screws to secure CM-150 CA to the mounting location.
DIN Rail Mount Installation
The overall dimensions of each CM-150 CA, DIN Rail Mount device are 153 mm
(6 in) wide x 97 mm (3.8 in) deep x 31 mm (1.2 in) high. Make sure the mounting
location allows enough space for air to move freely around the device.
PCK#: 999-999999-99
Item: 9104 036 00112
ABCD abcd ABCD abcd 25CHR
ABCD abc 40CHR
DC: 0852 ABC 1234
SN: FFAB0099
PCK#: 999-999999-99
Item: 9104 036 00112
1234
ABCD abcd ABCD abcd 25CHR
MAC: XXXXXXXXXXXX
ABCD abc 40CHR 00
10
DC: CM-150 CA 0852 ABC 1234 Product Guide
FFAB0099 IP: xx.xxx.xxx.xxx
SN:
1234
MAC: XXXXXXXXXXXX
00
IP: xx.xxx.xxx.xxx
Included in the box, Surface Mount
CM-150 CA, Surface Mount
2.5 mm (0.25 in) hex wrench
DMX termination pin jumper
(2) Spare fuses
(2) Connector caps
Included in the box, DIN Rail Mount
CM-150 CA, DIN Rail Mount
DMX termination pin jumper
(2) Spare fuses, attached inside housing
208 mm (8.19 in)
184 mm (7.24 in)
198 mm (7.8 in)
153 mm (6.02 in)