Craftsman 917.2565 Owner's Manual page 21

....... i
ERVICE
TO REPLACE MOWER BLADE DRIVE BELT
(See Fig. 21)
The mower blade drive bett may be replaced without tools.
Park the tractor on feve! surface. Engage parking brake.
BELT REMOVAL-
- Remove mower from tractor (See "TO REMOVE
MOWER" in this section of this manual).
, Work belt off both mandrel pulleys and idler pulleys.
, Pull belt away from mower.
BELT INSTALLATION -
, Install new belt in reverse order of removal.
o Make sure belt is in all pulley grooves and inside all belt
guides.
- Install mower in reverse order of removal instructions.
ADJUSTMENTS
MANDREL IDLER
PULLEY PULLEYS
WITH PARKING BRAKE "ENGAGED"
\
\
\
\
NUT
FiG. 22
OPERATING
ARM
i
!
MANDREL
PULLEY
FiG, 2t
TO ADJUST BRAKE (See Fig. 22)
Your tractor is equipped with an adjustable brake system
which is mounted on the right side of the transaxle.
If tractor requires more than six (6) feet stopping distance
at high speed in highest gear, then brake must be adjusted.
* Dep tess clutch/brake pedal and engage parking b rake.
Measure distance between brake operating arm and
nut "A" on brake rod,
TO REPLACE MOTION DRIVE BELT
(See Fig, 23)
Park the tractor on level surface. Engage parking brake.
For assistance, there is a belt installation guide decal on
bottom side of left footrest.
• Remove mower (See "TO REMOVE MOWER" in this
section of this manual.)
• Remove upper belt keeper.
= Remove belt from stationary idler and clutching idler.
Pull belt slack toward rear of tractor. Remove belt
upwards from transaxle pulley by deflecting belt keep-
ers.
- Pull belt toward front of tractor and remove downwards
from around engine pulley.
o Install new belt by reversing above procedure.
IMPORTANT: MAKE SURE UPPER BELT KEEPER IS
POSITIONED PROPERLY BETWEEN LOCATOR TABS.
If d !stance is other than 1 -i/2", loosen jam nut and turn
nut "A" until distance becomes 1-1/2". Retighten jam
nut against nut "A".
Road test tractor for proper stopping distance as stated
above. Readjust if necessary. If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary. Contact your nearest au-
thorized service centeddepartment.
PULLEY
CLUTCHING
IDLER
iDLER
TRANSA>
PULLEY
TABS
KEEPER
-'LT
21 FIG. 23