Craftsman 917.25147 Owner's Manual page 24

SERVICE ADJUSTMENTS
/
"POSITIVE" (+)
"NEGATIVE" _-J
I L.H. PANE_I
| BOLT ] _--_,
• 3 0
FiG. 26
TO REPLACE HEADLIGHT BULB
Raise hood.
Pul bulb holder out of the hole m the Backside of the
grill.
Replace DUIOIn hOlder and push DUIDnolaer secure,
back into the ho_e n tile backs:de of the grit
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring. See electrical wiring diagram in the
Repair Ports section of th s manual
TO REPLACE FUSE
Replace w_m 30 amo au_omotwe4ype p_ug-in fuse The
fuse holder is located benmna the dash,
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 27)
Raise hood.
UnsnaD neaa ght w_re connector.
Stand in front of tractor. Grasp hood at sides titttoward
engine and lift off of tractor•
To replace reverse aoove oroceeures.
_HOOD
HEADLIGHT
WIRE
CONNECTOR
t'
FIG. 27
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig, 28)
The throttle control nas been oreset at the factory and
adjustment should not be necessary. Check ad ustment as
described De=ow oefore loosening cable. "adjustment s
necessary, proceed as follows:
With eng ne nor running, move tnrottie centre lever to
fast (,1_,)oosmon.
Check that swivel is against side of quarter circle. If it
is not. loosen cable clamp screw and pull cable back
unt swive s against auarter circle. Tighten cable
_._, ip screw securely.
CLAMPSCREW .f'_--'__
Y,
QUARTER
CIRCLE \
?
_ SWtVEL
FIG. 28
24
TO ADJUST CHOKE CONTROL (See Fig. 29)
The cnoKe centre nas eeen oreset at tne factory aria
aojus_ment should not be necessary. Check adjustment as
aescrlDec below before loosening cable. If adjustment IS
necessary uroceea as fc ow,s