Low Battery Warning; Installing Batteries; Synchronize Remote Sensors With The Base Station - ThermoPro TP-65S Instruction Manual

To access CHANNEL SELECTOR and RESET buttons, you need to unscrew the cover as per Fig.
CHANNEL Selector (1,2,3): Slide to set Channel 1,2 or 3.
RESET: Press once to reset the remote sensor.
: Press and hold for 2 seconds to turn ON/OFF the unit.

Low battery Warning

If the battery power (base station or remote sensor) is low, there will be low battery icon showing on the base
station display.
If the low battery icon for base station shows up, please replace the batteries with new one.
If the low battery icon for remote sensor shows up, please charge the remote sensor as soon as you can.

Installing Batteries

1. Base station: open the battery compartment of the base station and insert two "AAA" batteries with correct
polarity.
2. A built-in rechargeable lithium battery is installed in the remote sensor. Although there could be some power
in the rechargeable battery before the unit leaves factory, it is always good to fully recharge it before using by
following the below steps:
a. Connect the charger to the charging socket located on the back of the remote sensor;
b. Plug the charger into a standard AC outlet;
c. The red light on the remote sensor will light up;
d. Charge it for at least 4 hours until the light changes from red to green which indicates charging is complete.

Synchronize Remote Sensors with The Base Station

1. Place the remote sensor near the base station;