Table of Contents
Advertisement
14
4 Initial Installation Procedure
Our Infrared Rotisseries are packed for safe transport, so that they can reach their
destination without any damages. However we advise an examination of Infrared
Rotisseries right after delivery.
Attention! Do report visible damages immediately!
4.1 Unpacking
• Open the box and take out the wrapping and filling material carefully.
• Take out all single parts and check whether these are complete (compare with enclosed dis-
patch documents).
• Now please remove the cardboard packaging and all wrapping and covering folios from the ro-
tisserie.
4.2 Installation
Install the unit and set it up at the desired place. Make sure that the unit is visible to
your customers to create a demand for your food offer and increase your sales.
During installation please note the following:
• Install the feet of the unit and set it up at the place as wanted.
• Set up the unit on an even, horizontal surface! Line up the unit horizontal.
• Observe that all slots for air supply and ventilation are held free and are at least
100 mm away from walls or similar things which could block the slots.
• Take care that the area around the rotisserie is free in order to load, unload, clean
the unit or that maintenance works can be done smoothly.
• The unit has to be set up in a way that the surrounding area can be cleaned.
4.2.1 Place of operation
Important! The rotisserie has to be set up on an even, stable and fireproof surface in
a good ventilated room and below an existing ventilation hood. Depending on the
model the unit can be placed free in a room or at a temperature-resistant wall or in
one line with other equipment. A minimum distance of 200 mm from walls made of
inflammable material has to be observed. If these distances fall below corresponding
heat protection measures have to be made, for instance tiling of walls or application of
a radiation protection. Before you install the unit check the type plate, whether the unit
is approved for the the local existing kind of gas. If the kind of gas indicated on the
type plate does not agree with the required kind of gas, the installation of the rotis-
serie is not allowed until the unit has been adjusted according to the requirements.
Note! When installed in a sales vehicle, make sure that the provided converter cre-
ates a sinusoidal rotating field.
Note! It is not allowed to set up a workplace in the area of radiation heating as it is
too hot there.
printed: 03/2012 Subject to change!
Initial Installation Procedure
< RTUserManual.doc
Advertisement
Table of Contents
