Restarting The Reader; Using Safe Mode - Omron V740-BA50C24-US Operation Manual

1.5.2 Restarting the Reader

Use this procedure to recover from a reader error.
1. Click the restart link on the navigation menu.
2. Click the restart button and the OK button on the
confirmation dialog.
Wait for at least 60 seconds for the reader to boot
up. The Power/Heartbeat LED is solid green while
the reader boots. When the LED begins blinking,
the boot process is complete.
V740 RFID READER/WRITER, ANTENNA
OPERATION MANUAL

1.5.3 Using Safe Mode

Use the Safe Mode button on the reader connector
panel to recover from errors that disable the reader.
Safe mode operation restores factory default settings
as follows:
Firmware Version: ...............factory installed version
Item
UHF Power
Class 1 96 -bit Support
Hostname
NTP Server
Domain Name
Primary DNS Server
Secondary DNS Server
Default Gateway
The browser-based interface pages are displayed in
red when operating in Safe mode and the reader
function is restricted. Only functions for changing
settings are available, functions for tag operation are
not available. In most cases, the reader will need to
be reconfigured for operation with the reader
application after starting in Safe mode.
1. Disconnect power from the reader.
2. Depress and hold the Safe Mode button, using a
nonconductive object, while restoring power to the
reader. Keep the Safe Mode button depressed
until the reader boots completely (the green
Power/Heartbeat LED blinks).
Safe Mode button
3. Factory-default settings are restored.
4. Use the browser-based interface to configure the
reader for use with your system.
This PC must be configured with an IP address
and subnet mask compatible with the reader
default settings. For example: IP address
10.0.0.10, net mask 255.255.255.0.
18 of 45
Default Value
30.0
OFF
mercury4
louie.udel.edu
thingmagic.com
10.0.0.1
none
LAN
2005-07, REV.01
©OMRON CORPORATION 2005