Table of Contents
Advertisement
TROUBLE-SHOOTING
AND MAINTENANCE
Inspect and properly
tighten
all parts of the cross training
system each time you exercise.
Replace
any
wom parts immediately.
The cross training
system
can be cleaned
using a damp cloth and mild non-
abrasive
detergent.
Do not use solvents.
ADJUSTING
THE CABLES
If there is too much slack in the cables,
the
cables can be adjusted.
To tighten the cables,
find the 5/16" Nylock
Nut (4) near the lower end
of the Front Upright
(76). To tighten the cables,
hold the 5/16" x 4" Bolt (27) and turn the Nylock
Nut clockwise.
If the cables cannot be tightened
enough
by turning
the Nylock Nut, see the
instructions
below.
Locate the two 3 1/2" Pulleys (55) attached
to the
"1" Plates (75). The 'T' Plates have three adjust-
ment holes for tightening
the cables.
Remove
the
3/8" Nylock Nut (15) and 3/8" x 1 3/4"
Bolt (26)
attaching
the lower Pulley to the 'T' Plates. Attach
the Pulley to the next higher hole in the "1"
Plates. Turn the 5/16" Nylock
Nut (4) clockwise
umii the cabies are tight (see Orawing
i).
If the cables still cannot
be tightened
enough,
see the back cover of this owner's
manual
to
order new cables.
27
-26
55 _
21
Hide quick links:
Advertisement
Table of Contents
