Your Range; Removable Oven Door; How To Care For Your Range - GE JBP23 Use And Care Manual

Finishes
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid resistant. How-
ever, any acid foods spilled (such
as fruit juices, tomato, or vinegar)
should not be permitted to remain
on the finish .
Oeaning Under the Range
The area under the range of models
equipped with a bottom drawer can
be reached easily for cleaning by
removing the bottom drawer. To
remove , pull drawer out all the way,
tilt up the front and remove it. To
replace, insert glides at back of
drawer beyond stop on range glides:
Lift drawer if necessary to insert
easily. Let front of drawer down,
then push in to close.
Removable Oven Door
To REMOVE door , open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place .
How to Care for Your Range
Proper care and cleaning are
important so your Range will give
you efficient and satisfactory
service . Follow these directions
carefully in caring for your range
to assure safe and proper
maintenance .
Locations shown for:
1 Oven Vent Duct
2 Calrod® Surface Units
3 Oven Lamp
Oven Vent Duct
Your Range is vented through a
duct located under the right rear
Calrod® unit. Clean the duct often.
To remove:
• Make sure unit is cool.
• Lift up right rear surface unit.
• Remove drip pan and ring.
• Lift out oven vent duct.
To replace:
• Place the part over the oven vent
located below the cooktop with
opening of the duct under the
round opening in the drip pan . It
is important that the duct is in
the correct position so moisture
and vapors from the oven can be
released during oven use. NOTE:
Never cover the hole in the oven
vent
duct with aluminum foil or
any other material. This prevents
the oven vent from working
properly during any cooking
cycle.
22
Oven Lamp
CAUTION: Before replacing your
oven bulb, disconnect the electrical
power for your range at the main
fuse or circuit breaker panel or pull
plug. Be sure to let the lamp cover
and bulb cool completely before
removing or replacing.
To Remove:
• Remove the 3 slotted screws in
the lamp co er as shown in
diagram.
• Detach lamp cover and remove
bulb.
To Repace:
• Put in a new 40-watt appliance
bulb.
• Install lamp cover. Replace 3
screws and tighten , making sure
cover fits flush with oven wall.
• Reconnect electrical power to the
range .