Installing The Head - Sears 113.21308 Owner's Manual

.
4.
Locate support lock handle among loose parts.
Install support lock handle from left side into table
support. Raise table to working height by sliding it
on the column and then tighten lock handle by
hand.
TABLE
SUPPORT
COLUMN
TABLE
iNSTALLiNG THE HEAD
CAUTION: The head assembly weighs about 45
pounds. Carefully lift head.
1, Remove protective covering from head,
2. Carefully lift head above column tube and slide it
down on the column as far as it will go, Align head
with table and base.
-_:z:
COLUMN
HEAD LOCK
SET SCREWS
3. Using a 4mm Hex "L" wrench tighten the head lock
set screws on the right side of the head.
HEAD
11