Australia/New Zealand - ActiGraph CPW01 Technical Manual

Document No:
E.200.4038
Revision: 0
ICES-3
(B)/NMB-3(B)
CAN ICES-1
(B)/NMB-1(B)
Australia/New
Zealand
CentrePoint Insight Watch Technical Manual
● EN 61000-4-8:2010 – Electromagnetic Compatibility – Part 4: Testing and
measurement techniques – Section 8: Power frequency magnetic field immunity
test
● EN 55011:2016 + A1:2017 – Industrial, scientific and medical equipment -
Radio-frequency disturbance characteristics - Limits and methods of
measurement
● EN 301 489-1 – Electromagnetic compatibility and Radio spectrum Matters
(ERM); ElectroMagnetic Compatibility (EMC) standard for radio equipment and
services; Part 1: Common technical requirements
● EN 301 489-17 –Electromagnetic Compatibility (EMC) standard for radio
equipment; Part 17: Specific conditions for Broadband Data Transmission Systems
● EN 300 328 – Electromagnetic compatibility and Radio spectrum Matters (ERM);
Wideband transmission systems; Data transmission equipment operating in the
2.4 GHz ISM band and using wide band modulation techniques
The CPW01 complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
The CPW01 and Charger complies with the Canadian electronic emission standard CAN
ICES-3 ​ ( B)/NMB-3(B)
The CPW01 and Charger complies with the Canadian interference-causing equipment
standard CAN ICES-001 (B)/NMB-1(B).
The CPW01 and Charger complies with the Australia Communications and Media
Authority (ACMA) and carry the Regulatory Compliance Mark (RCM) since they acceptably
passed all electrical emission tests.
The CPW01 complies with the Australian and New Zealand standards:
● AS/NZS 4268 (2008) – Radio equipment and systems – Short range devices
● AS/NZS CISPR 11:2011 - Information technology equipment – Radio disturbance
characteristics – Limits and methods of measurement
Page 9 of 10