Smart Equipment™ Firmware Version 3.2 Basic Unit Control Board Navigation Examples - York YD480 Series Installation Manual

SMART EQUIPMENT™ FIRMWARE VERSION 3.2 BASIC UNIT CONTROL BOARD NAVIGATION EXAMPLES:
The following document details the navigation and viewing of
the LCD display screen equipped as a standard item on the
Smart Equipment™ control installed within various commercial
UPG packaged and split system equipment. The following
information provides a step-by-step demonstration on how to
Step 1 - After the start-up countdown is
"Status & Alarms" screen. When the cursor
is on the top "Status" line hit the ""ENTER""
button. This action steps the LCD display into
the status mode. Hit ""ENTER" to view the
status menu.
Step 2 - Scroll down to "DVent-
Mode". This is the demand ventilation
mode.
>DVent-Mode
OprST
ENTER
CANCEL
JOY +
-
Johnson Controls Unitary Products
Understanding the Local LCD
After you apply power to your Rooftop Unit (RTU), a start-up countdown begins
on the Unit Control Board (UCB) LCD. When the controller is ready, the screen is
blank because no faults are present. Use the joystick and the two push buttons
below the LCD, to navigate through the menus.
Step 3 - When the cursor is on the "DVent-Mode"
hit "ENTER" to view the status of this mode. In
this case a CO2 sensor is not installed, thus
Demand Ventilation or DVent is disabled.
DVent-Mode
Disabled
Press Enter
ENTER
CANCEL
C PWR
Step 5- By pushing the joystick down, the cursor toggles to OprST
(Operating Space Temp).
DVent-Mode
>OprST
ENTER
CANCEL
JOY +
- C PWR
Step 6- By pushing "ENTER" the actual OprST (Operating Space Temp) appears. Pushing
the joystick down scrolls through SAT, RAT, OAT and other available sensor readings.
SAT
70.5 F
ENTER
CANCEL
JOY +
- C PWR
Press the "Cancel" button to exit each menu level. Repeatedly pressing
navigate the basic status menu and how to change basic
configuration settings. The basic navigation steps outlined in
this short demonstration applies to most menus within the
Smart Equipment™ control.
>Status
Alarms
ENTER
CANCEL
JOY +
Push Cancel
JOY +
- C PWR
OprST
70.5 F
Press Enter
ENTER
CANCEL
JOY +
RAT
70.5 F
ENTER
CANCEL
JOY +
- C PWR
Press Enter
- C PWR
Step 4 - To exit out of the
"DVent-Mode status screen
push "Cancel". The screen
returns to that shown below.
>DVent-Mode
OprST
ENTER
CANCEL
JOY +
- C PWR
OprOAT
70.5 F
ENTER
CANCEL
JOY +
- C PWR
5012886-YIM-B-0517
- C PWR
21