Operation - Lightmaxx Vega Halo 90 User Manual

Operation:

Make sure everything is connected before switching on. Use only high-quality cables that are as
short as possible for the connections.
DMX mode:
Connect the DMX input of your device to the DMX output of your DMX controller, your DMX
software or the DMX output of a device already in your DMX chain. Always use DMX cable with a
110 Ohm resistor for this connection. Address the device according to your DMX confi guration. The
following tables show the respective DMX modes of the individual devices with the corresponding
values and functions.
Static, Auto or Sound mode:
The device contains automatic programs that run according to fi xed schemas (Au) or are recalled via
the built-in microphone to match the music (Au). The selection of the respective mode takes place
via the menu directly on the device.
Operating mode master/slave:
If you connect several devices of the same type via DMX, they can be controlled simultaneously
via the master device. To do this, set the desired function on the fi rst device in the chain; the other
devices in the series must now be set as „slaves". Now the fi rst device in the chain gives the function
to all other devices and all devices run simultaneously.
17