Samsung GH052EAM Service Manual page 16

7
8
9
10
11
12
Setting is not required if you must
a value which has a
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key,
The display part shows
Press the Mode Selection key,
The display part shows
Step 4 : Pressing the ON/OFF button (
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON(
pleted. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote control.
Second, Re-insert the battery into the remote control.
Third, Press ON/OFF button(
• Error Mode
1 st If all lamps of indoor unit are flickering, Plug out, plug in power plug again and press ON/OFF key to retry.
2 nd If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for its model.
Samsung Electronics
7
8
9
10
11
12
default.
to set the display part to
.
to set the display part to
.
)
) lamp of the display is flickering at the same time, then the input of option is com-
) with the direction of remote control for set.
Press button, then the default value is
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
Push the button to set the display panel to
Every time you push the button, the display panel reads
. . .
and check the display part.
and check the display part.
Set up the Model Option
.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
.
repeatedly.
15