Workzone 50501 User Manual page 9

High Pressure Washer
5.3 Operation
5.3.1 Connect the high-pressure hose with the locknut to the high-
pressure outlet of the cleaner, then tighten it.
5.3.2 Connect one side of the inlet hose with inlet nipple to the cleaner,
another side to the water faucet, tighten with a clamp. (Note: there is
a seal ring in nut, no losing.)
5.3.3 Connect the water supply and the power source, then turn on the
power switch of the cleaner and the gun trigger, as air has been
exhausted, the cleaner is ready for operation.
NOTE: The switch is installed in the black rubber water-repellent mat of
the appliance.
In case a water tank is used to supply water, water should ow into the
pump through the inlet hose and the trigger be turned on so as to exhaust
the air in the hose at the same time. When the pump works properly, place
the inlet hose in the water tank rapidly， the water level in the tank should
not be lower than the cleaner itself, and the inlet hose must be tted a
lter.
5.3.4 The lance has an adjustable nozzle to allow you to vary the width of
the spray. To adjust the width of the spray, move the nozzle as
shown in gures 4
Twist
Twist
9
acs@americancustomerservice.com
Figure 5
Operation Rules - Operation
Figure 2
Wide spray
Figure 2
Tight spray
USA
AFTER SALES SUPPORT
1800 505 8311
USA