Workzone 50501 User Manual page 10

High Pressure Washer
5.3.5 During the cleaning, the distance between the nozzle and the object
surface to be cleaned should not be too far, normally not more
than 11.81in (30cm), as the impulsive force decreases with the
increase of the distance.
• You should hold the gun trigger firmly during the cleaning.
• The safety value doesn't control the gun during operation, but only
prevents it from opening unintentionally.
• Sprayed the human beings or electric equipment is forbidden.
• Don't place the power wire on the road so as avoid breaking the wire.
• The nozzle used in the cleaner are supplied by our factory.
5.3.6 After the cleaning is nished, open the trigger, switch off the pump
and unplug the power cable from the mains. Close the water inlet
and detach the appliance from the water connection. Pull the trigger
until there is no more pressure in the appliance, and secured the
trigger with safety button against unintentional opening.
5.3.7 GFCI Operation Instruction:
This pressure washer is provided with a ground fault circuit inter
rupter (GFCI) built into the plug of the power supply cord. This
device provides additional protection from the risk of electric shock.
Should replacement of the plug or cord become necessary, use only
identical replacement parts that include GFCI protection.
Use only extension cords that are intended for outdoor use. These
extension cords are identi ed by a marking "Acceptable for use with
outdoor appliances; store indoors while not in use." Use only exten
sion cords having an electrical rating not less than the rating of the
product. Do not use damaged extension cords. Examine extension
cord before using and replace if damaged. Do not abuse extension
cord and do not yank on any cord to disconnect. Keep cord away
from heat and sharp edges. Always disconnect the extension cord
from the receptacle before disconnecting the product from the
extension cord. Always plug the extension cord into a GFCI
protected outlet. To avoid the possibility of the tool plug getting wet
when using an extension cord, arrange a "drip loop" in the cord
connecting the pressure washer to the extension cord. The "drip
loop" is that part of the cord below the level of the connector which
prevents water travelling along the cord and coming in contact with
the connection. If the plug does get wet, DO NOT unplug the cord.
Disconnect the fuse or circuit breaker that supplies power to the
tool, then unplug and examine for presence of water in the connection.
AFTER SALES SUPPORT
1800 505 8311
USA
Operation Rules - Operation
acs@americancustomerservice.com
USA
10