Water Source Status Screen - Baseline BaseStation 3200 Quick Start Manuals

Advanced irrigation controller
Hide thumbs Also See for BaseStation 3200:
Table of Contents

Advertisement

BaseStation 3200 Quick Start Guide
Next Start: The estimated next start date and time for the program. In some cases, the start
condition for a program makes it difficult to accurately estimate when the next start will occur.
Consider the information in this field as helpful, but remember that it might not be perfectly
accurate depending on the program settings.
Avg Time: An average of the last 3 runtimes.
Avg Water: An average of the amount of water used during the last 3 runtimes.
If you leave the Detailed Status By Program screen displayed, it will continue to display when the
controller dial is in the RUN position until the controller is reset. At that point, the Zone Status
screen redisplays.
When the Detailed Status By Program screen is displayed, press the Previous button to return to
the All Zones & Programs Status screen, or press the Next button to go to the Water Source Status
screen.

Water Source Status Screen

When the controller dial is in the RUN position and the main Zone Status screen is displayed, press
the Next button three times to display the Water Source Status screen.
Press the + or – button to cycle through the water sources on the controller.
The colored box on the left indicates the water source status. Refer to the Status Colors topic on
page 6 for an explanation of the colors.
The following information is available in the fields:
Month Used: The cumulative total used from this
water source during the month.
Budget: The amount of water that can be taken from
this water source during the month.
Empty: If an empty condition has been set up for this
water source, this field shows OK or EM for empty. If
no empty condition exists, the field shows DS for
disabled.
Flow Path: This field shows the control point and mainline that are connected to this water source.
When the Water Source Status screen is displayed, press the Previous button three times to return
to the Zone Status screen, or press the Next button to go to the Control Point Status screen.
Page 4

Advertisement

Table of Contents
loading

Related Products for Baseline BaseStation 3200

Table of Contents