Adjusting The Transmitter; Tuning The Speakers - Acoustic Research wireless speakers AW877 Installation And Operation Manual

Adjusting the Transmitter

1. Turn on your audio source (for example, A/V receiver, TV, stereo, etc.) and play
music at a normal listening volume.
Transmitter Back View
Built-in audio
input cable
Transmitter power
input jack select switch
Transmitter Front View
Transmission Indicator Light

Tuning the Speakers

Standby/ Power/Tuning/
Volume Control
Tuned
Indicator
Speaker Front View

2. Set the channel select switch on the back of the
transmitter to one of the transmitter's three
broadcast frequencies: 1, 2 or 3. If you experience
poor reception or interference, try choosing a
different frequency by moving the channel select
switch to another position.
Channel
When the transmitter is receiving an audio signal
and is ready, the light on its front turns blue.
Note
If the light on the front of the transmitter does not turn
on, please check the following:
- Confirm the transmitter AC power adapter is
- Confirm the cable from the transmitter is securely
1. Press the Power/Volume/Scan control on each
speaker to turn it on. The STDBY./TUNED light
illuminates red while the speaker is tuning to the
transmitter. The STDBY./TUNED light turns blue
when the speaker is tuned to the transmitter—you
should hear sound coming from the speaker now.
Note: If the speaker is not tuned or if the transmitter is
not connected properly, the STDBY./TUNED indicator
will not turn from red to blue. If this occurs, please see
the troubleshooting section of this manual.
2. Adjust the volume on each speaker as desired.
securely connected.
connected to the audio source output (TV, A/V
receiver, etc.).