Conducted Noise; Voltage Tolerance - Seagate CONSTELLATION ST9160511NS Product Manual

3.8.2

Conducted noise

Input noise ripple is measured at the host system power supply across an equivalent 80-ohm resistive load on
the +12 volt line or an equivalent 15-ohm resistive load on the +5 volt line.
• Using 12-volt power, the drive is expected to operate with a maximum of 120 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
• Using 5-volt power, the drive is expected to operate with a maximum of 100 mV peak-to-peak square-wave
injected noise at up to 10 MHz.
Note. Equivalent resistance is calculated by dividing the nominal voltage by the typical RMS read/write
current.
3.8.3

Voltage tolerance

Voltage tolerance (including noise):
5V ±5%
12V ±5%
Constellation Serial ATA Product Manual, Rev. D 13