Principal Operating Parts; Know Your Unit - Coats gts series Operation Instructions Manual

Principal Operating Parts

Do It Now!
Now is a good time to contact product service to
start warranty, otherwise warranty starts at time of
shipment.
Single-Point Nozzle
Replace any damaged or missing safety
decals. They are available from COATS, (800)
688-6359.
1 Tilt Tower — Support for horizontal and vertical
slides.
Release Valve — Allows the manual release of air
2
pressure from tire when clip-on chuck is attached to
tire valve.
3 Air Inflation Gauge — Registers tire pressure when
clip-on chuck is attached to tire valve stem and inflation
nozzle is released.
4 Important Safety Decal — Important safety infor-
mation for the operator. DO NOT obstruct with tire
stickers or other materials.
2 •

Know Your Unit

Compare this illustration with the unit before placing it
into service. Maximum performance and safety will be
obtained only when all persons using the unit are fully
trained in its parts and operation. Each user should learn
the function and location, of all controls.
Prevent accidents and injuries by ensuring the unit is
properly installed, operated and maintained.
1
2
3
4
5
6
*5
with a single-point nozzle bead sealer. Expands tire
sidewall to bead seat area of rim to seal tire to rim and
allow inflation.
6 Inflation Pedal — Three-position pedal that registers
tire pressure, allows inflation of tires through air hose
and clip-on chuck or allows air flow through bead sealing
nozzle.
7 Robo-Arm
for runflat and low profile tires.
8 Robo-Arm Valve (if equipped) — Controls verti-
cal movement of robo-arm slide cylinder. Used to set
correct vertical position to maintain robo-arm disk-asist
wheel clearance.
Important: Always read and follow operating instructions.
9
Bead Sealing Nozzle — Some models are equipped
(if equipped) — Provides extra leverage
®
8
7