Fisher & Paykel GD75IA1 Installation Instructions Manual page 7

10. Align the discharge elbow up with the waste pipe (refer to
fig.11) so that the waste disposer is correctly positioned,
prior to engaging with the mounting assembly.
11. Guide the waste disposer up to the sink flange (fig. 9).
Engage the groove of the splash guard around the ridge at
the bottom of the sink flange. A slight rocking motion may
be required to help ensure a proper fit.
12. While still supporting the body of the waste disposer,
tighten the screw clamp around the rubber splash guard
(fig.10). The waste disposer will now hang by itself.
13. Connect the discharge elbow up with the waste pipe
(fig.11) and tighten the slip nut on the drain pipe.
If you need to rotate the waste
disposer to connect with the waste
pipe, it is important to make sure
the sink flange does not turn.
Movement of the sink flange will
break the seal created when
installed. If this occurs, disengage
the waste disposer from the
discharge elbow and mounting
assembly Return to step 10 to
realign the waste disposer before
repeating steps 11-13.
Ensure that the reset button is
readily accessible after installation
of the waste disposer.
https://producthelp.fisherpaykel.com/nz/Clean/Dishwashing_Accessories/GD75IA1/User_Guide_GD75IA1/02_Installation_instructions
Fig. 9 Engage the waste disposer
Fig. 10 Tightening the clamp
Fig. 11 Connecting the drain outlet
Updated: Fri, 01 Mar 2019 07:04:48 GMT
Powered by
7