Fisher & Paykel GD75IA1 Installation Instructions Manual page 5

3. Apply a small amount of plumbers putty to the lip of the sink
flange and position the sink flange into the sink drain hole
ensuring that the rubber gasket on the underside of the
sink flange is firmly in place (fig.4).
4. Approaching from under the sink, slide the protector ring
and mount ring onto the underside of the sink flange. Fit
the flange ring into the track on the sink flange, then tighten
the 3 mounting screws evenly and securely (fig.5).
Ensure that the mounting assembly
connection is fixed securely and
tightly.
No dishwasher connection required
If a dishwasher is not being connected to the waste disposer,
please proceed to step 7.
Connecting to a dishwasher
If you are connecting to a dishwasher, please continue with steps
5 & 6.
5. Using a blunt instrument (steel punch or wooden dowel),
knock out the entire plug at the end of the dishwasher drain
inlet (as shown in fig.6). Do not use a screwdriver or sharp
instrument. When the knockout plug falls into disposer, you
may remove it or simply grind it up when the disposer is
used. This will not damage the disposer in any way, but
may take some time to grind, over the course of several
uses.
https://producthelp.fisherpaykel.com/nz/Clean/Dishwashing_Accessories/GD75IA1/User_Guide_GD75IA1/02_Installation_instructions
Fig. 4 Fitting the flange into the sink drain hole
Fig. 5 Fixing the mounting system to the
underside of the sink
Updated: Fri, 01 Mar 2019 07:04:48 GMT
Powered by
5