Safety Information; Building Regulations - Aqualisa QUARTZ DIGITAL SERIES Installation Manual

Important information

Safety information

This product must be installed by a competent person in accordance with all relevant current Water Supply Regulations.
ALL SHOWERS REQUIRING AN ELECTRICAL CONNECTION MUST BE INSTALLED BY A QUALIFIED PERSON
FOLLOWING THE LATEST REVISION OF BS 7671 (WIRING REGULATIONS) AND CERTIFIED TO CURRENT

BUILDING REGULATIONS.

This product is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning safe use of the product, understanding the hazards involved, by a person responsible for their safety.
Children should be supervised to ensure they do not play with the product.
Cleaning and user maintenance shall not be made by children without supervision.
This system should be installed so that other taps or appliances operated elsewhere within the premises do not
significantly affect the flow.
The Digital Bath has a non-adjustable factory maximum set run time of 12 minutes.
The Digital Bath must not be used with a hot water supply temperature over 65°C.
The processor is supplied factory pre-set at a maximum temperature of 45°C. The maximum temperature is fully
adjustable to suit site conditions. If adjusted, we recommend the outlet temperature is set to a MAXIMUM of
46°C.
The Digital processor must be installed in an accessible location for servicing and maintenance.
The Digital processor must not be installed in situations where either the ambient temperature is likely to exceed
40°C or where freezing may occur.
The control must not be installed in situations where the ambient temperature is likely to fall below 5°C or rise
above 40°C.
We do not recommend the use of Quartz Digital in steam therapy facilities.
This appliance must be earthed.
Quartz bath with overflow filler installation instructions Page 4