Troubleshooting - Vornado VMH10 Owner's Manual

TROUBLESHOOTING

PROBLEM
Unit fails to power on.
Airflow is diminished.
Unit is not producing
sufficient amount
of heat.
Unit is powered on
but there is no heat.
16 English
POSSIBLE CAUSE AND SOLUTION
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped
or blown fuse. Reset circuit breaker / ground fault circuit interrupter, or
replace fuse. See IMPORTANT INSTRUCTIONS.
Unit has overheated. Automatic Safety Shut Off has initiated. See
RESET HEATER.
Tip-over switch on bottom of unit has been tripped and safety shut-off
system has cut power to heater. Place heater on level surface. See
SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact
Consumer Service for assistance.
Check filter and clean as necessary. See CLEANING.
Ensure unit is set to High Heat.
Close all doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take
several minutes.
Turn Power Off and unplug unit. A cylindrical plunger is on bottom of
unit. Push in 4–5 times, ensuring it is not stuck. Set unit down on flat
surface. Ensure power cord is not under unit. Plug unit in and turn Power
On. Turn to highest heat setting.