Bison HangTime Owner's Manual page 13

10) Backboard Assembly
Mount the lower Backboard Assembly (D) mounting tube first to the Main
Extension Arm (B) using one 3/4" X 12 1/2" Hex Bolt (P) and one 3/4" Lock Nut
(Q). Next, attach the upper Backboard Assembly (D) mounting tube to the Parallel
Linkages (C) using one 3/4" x 11 1/4" Hex Bolt (O) and one 3/4" Lock Nut (Q).
NOTE: Tighten the lock nuts
down and then back off a 1/4
turn to allow the joint to pivot
when adjusting the system up
and down.
11) Level Backboard
Check face and top of backboard to see if it is level and plumb. If not, correct by
adjusting the 5/8" J-Bolt Hex Nuts (L) located both below and above the Vertical
Post (A) base plate.
REV. 10/10/17
CAUTION: ATTACHING THE
BACKBOARD REQUIRES AT
LEAST FOUR CAPABLE ADULTS.
13