Updating The Firmware; Linux - Broadcom NetXtreme-C User Manual

NetXtreme-C/NetXtreme-E User Guide
Table 14: Windows Event Log Messages (Continued)
Message ID Comment
0x0014 Incompatible firmware version.
0x0015 Single interrupt.
Table 15: Event Log Messages
0x0016
0x0017
0x0018
0x0019
0x001A
0x001B
0x001C
0x001D
0x001E
0x001F
0x0020
0x0021
0x0022
0x0023
0x0024
0x0025
0x0026
0x0027
0x0028

7 Updating the Firmware

7.1 Linux

To update the Linux firmware:
1. Download the firmware upgrade package from:
?pg=Ethernet+Connectivity,+Switching,+and+PHYs&pf=Ethernet+Network+Adapters+-
+NetXtreme&pn=All&pa=Firmware&po=&dk=
2. Execute the following commands:
tar zxvf nxe_fw_upgrade.tgz
3. Execute the following command:
./fw_install.sh
4. Follow the install script steps.
Firmware failed to respond within allocated time.
Firmware returned failure status.
Firmware is in unknown state.
Optics Module is not supported.
Incompatible speed selection between Port 1 and Port 2. Reported
link speeds are correct and might not match Speed and Duplex
setting.
Incompatible speed selection between Port 1 and Port 2. Link
configuration became illegal.
Network controller configured for 25 Gb full-duplex link.
Network controller configured for 40 Gb full-duplex link.
Network controller configured for 50 Gb full-duplex link.
Network controller configured for 100 Gb full-duplex link.
RDMA support initialization failed.
Device's RDMA firmware is incompatible with this driver.
Doorbell BAR size is too small for RDMA.
RDMA restart upon device reset failed.
RDMA restart upon system power up failed
RDMA startup failed. Not enough resources.
RDMA not enabled in firmware.
Start failed, a MAC address is not set.
Transmit stall detected. TX flow control is disabled from now on.
https://www.broadcom.com/support/download-search/
.
NetXtreme-UG100
21