Electrical Specifications - Sharp 70FW-53I Service Manual

Da-50w chassis pal/secam system
Table of Contents

Advertisement

•Power Input ..................... 220V-240 Volts AC 50Hz
•Power Consumption
Normal Operation ..................................155W
(Method IEC 60107)
Stand-by Operation ....................................1W
•Audio Power Output Rating (MPO) / Impedance
Internal Left Speaker ....................... 10W, 7
Internal Right Speaker ..................... 10W, 7
Internal Centre Speaker .............. 10W, 7
•Speakers
Left / Right ........................................ 4 x 10cm
Centre .............................................. 6 x 13cm
•Convergence
Static (Centre)
between any two colours......................0.08cm
Dynamic after static equals zero
Within 10cm (4") circle.........................0.12cm
10-28cm (4-10") circle..........................0.20cm
Everywhere else...................................0.28cm
•Focus ....................... High Bi-Potential Electrostatic
•Sweep Deflection ...................................... Magnetic
•White Level
Set brightness control to get total picture tube cathode current of 600 µA under no signal condition.
Maximum necessary correction of each picture tube cathode current to get 8550 degrees K+1 MPCD.
Screen temperature should not exceed 15% of its original value.
X=0.290 ± 0.015
In order to comply with the European Norm 61000-3-2 regarding Electromagnetic compatibility (EMC),
it has been included mainly, in the PFC Circuit (Power Filter Correction), on every TV set manufac-
tured from January 2001.
On TV set manufactured before the above date (Serial Number
this modification is not required.
Part of this chassis is not isolated from the mains supply. When carrying out any servicing work,
ensure that an isolation transformer is connected in the mains supply.
To prevent electric shock, do not remove the cover unless you are qualified to do so. Refer servicing
work to a qualified engineer.
All manuals and user guides at all-guides.com

ELECTRICAL SPECIFICATIONS

Y=0.300 ± 0.015
Specifications are subject to change without prior notice.
EN 61000-3-2
WARNING
3
•Picture Intermediate frequency
L'..................................................33.9MHz
L, B/G, D/K,I................................38.9MHz
•Sound Carrier Trap
L'..................................................40.4MHz
L, D/K...........................................32.4MHz
B/G..............................................33.4MHz
I....................................................32.9MHz
•Adjacent Sound Carrier Trap
L'..........................................................32.4MHz
L, D/K, B/G..................................40.4MHz
I....................................................40.9MHz
•Adjacent Picture Carrier Trap
L'..........................................................41.9MHz
L, D/K,I.........................................30.9MHz
B/G..............................................31.9MHz
•Aerial Input Impedance
VHF/UHF ................. 75 ohm Unbalanced
•Tuning Ranges.......45.75MHz thru 855.25 MHz
VHF: IR A~J / S1~S41 CH (HIPERBAND)
E2~E12 / F2~F10
UHF: E21~E69 CH, I21~I69 CH
CATV Special Channels
800929 for 70FW-53E
70FW-53E
or previous),

Advertisement

Table of Contents
loading

This manual is also suitable for:

70fw-53ecg70fw-53e70fw-53enl70fw-53se

Table of Contents