Front Wheel, Front Suspension Device, Steering Device - Regal Raptor NAC12 Manual

Front wheel, front suspension device, steering device

Maintain information
Notes:
1、Do not press over-load on the wheels and put anything on the wheel. Pay attention not to damage
the wheel during maintaining.
2、 Pay attention not to damage the tire and rims due to no inner tube inside
3、 Please use the special "Off-tire pole" and rim protector when removing the tire out rim and avoid of
damaged wheel.
4、Please remove the disc when replacing the tire. Otherwise, please do not load any on the disc plate but hold the rim with the wood board.
Maintain standard
Bent radius of front wheel
jumpiness of front wheel
Bent radious of fork leg
oil capacity of fork
Fixture torque
Handlebar mounting bolt
fork bushing bolt
brake disc nut
fork leg bolt
front axle nut
failture diagnose
hard in controlling the handlebar
over tighten on the steering adjustment nut
steering axle damaged
twist when steering by the cables and operating wires.
low tire pressure
Impossible to operate the handlebar
fork bent
front axle bent, tire damaged
rear fork bent
noise in the front suspention
touch on the fork leg and bottom
less oil capacity
loose on fixture parts for suspensions
front wheel shaking
rim out of shape
Handle bar
remove
dismove the following parts from right handle bar
1. brake pump
2. handle switch
3. fuel accelerater handle grip
remove the following parts
1. clutch bar holder
2. handle switch
Item
vertical
horizontal
standard
24-30N.m
15-25N.m
14-16N.m
15-30N.m
55-65N.m
— 42 —
standard
257ml
brake pump mouting bolt 24-30N.m
steering adjustment nut 23-27N.m
braking seat bolt 10-14N.m
steering pole nut 90-120N.m
clutch seat 7-11N.m
loose on front wheel axle
tire no good
related mouting parts no well tigtened
related to the front wheel axle
balance of wheels no good
too soft of the front suspension
over work on the spring
a little leftover of oil capaicty
air pressure of fork no good
no usage of stickness oil
too hard of front suspension
oil no good quality inside the fork leg
no good adjustment of air pressure
fork legs bent
block-up of the oil passageway
no usage of stickness proper oil
brake pump fuel accelerater handle grip
handle switch
handle switch
clutch bar holder
limit
0.2mm
2.0mm
2.0mm
0.2mm