Operation Notice Items - Regal Raptor NAC12 Manual

item
front, rear wheel
wheel rim jump
wheel axle bent
tire air pressure
size
brake
brake
ignition loop
resistance value（20℃）once
2nd test without spark plug cap
charging system、DC generator
DC generator style
lighting, switch, meter
lighting, electric bulb
brake light, taillight
indicator light
fuse
batter capacity
voltage ends
charging current(standard)

Operation notice items

cylinder gasket, O ring ,clip hoop, open pin etc disassembled, you should
replace the new one
when tighten the screw, screw cap, bolt, please follow the first big then small,
first side then outside, per the specified fixture torque, on the cross
Please use special currency tool
when parts disassembled, pleas clean it before checking and measuring,
pease apply the grease on friction side when assembling.
please apply the special butter on special part.
please check every fixture and action status after assembled.
please remove the battery cathode before operation
Please check the connection, fixing and assembly status when done
please connect the anode when install the battery.
please apply the butter after anoding
please cover ends completely
Please check the reason and repair it when fuse is burned, then replace the
same spec fuse
please apply the cover and cap after operation.
please hold the connection peg to disassemble it, no pulling
standard
radial
horizontal
front wheel 0.225PMa
0.225MPa
rear wheel
front wheel 90/90-8
130/90-15
rear wheel
DOT3 or DOT4
0.36-0.4Ω
5KΩ
DC
12V
front light 12V-35W/35W
12V-21/5W
12V-10W×4
15A
12V-9Ah
13.0-13.2V(20 ℃)
0.9A(5h)
— 2 —
limit
2.mm
2.0mm
0.2mm