AvMap EngiBOX User And Installation Manual page 9

AvMap EngiBOX
Connection board
EngiBOX has several sensor input ports, which can be occupied variably according to the connected
engine type. On the back of the EngiBOX there are several connections, see Figure 5.
Note: See Table 1 or 2 for the connection specification relative to your engine type.
4 Stroke Engines - Connection Diagram
LEFT
external power positive input
external power negative input
output at external power voltage +
output at external power voltage -
RPM positive input
RPM negative input
EGT PTO R +
EGT PTO R -
EGT MAG R +
EGT MAG R -
Note: See the compatible sensor table for each parameter at page 8.
POWER +
POWER -
ALARM +
(disabled)
ALARM -
RPM +
RPM -
TEMP1 +
TEMP1 -
TEMP3 +
TEMP3 -
auxiliary power source for oil pressure
VPOIL sensor (not used for VDO resistive sensor
of 1 wire)
POIL oil pressure sensor input
oil temperature Ground (only if PT-100
GND
semsor is used)
TOIL oil temperature input
CHT or CT Ground (only if PT-100 sensor
GND
is used)
CHT / COOLT CHT or CT input
TEMP2 + EGT PTO L +
TEMP2 - EGT PTO L -
TEMP4 + EGT MAG L +
TEMP4 - EGT MAG L -
User and Installation Manual -
Figure 5
Table 1
RIGHT
9