LOWER
HANDLEBARS
HEX
BOLT
LONG
CARRIAGE BOLT
Figure 1
FLAT
WASHER
TRIANGLE
PLASTIC
KNOB
BUSHING
Figure 2
Figure 3
Assembly
Attaching the Handlebars
HEX NUT
1. Align the lower handlebars with the handlebar brackets, push a
TRIANGLE
KNOB
2. Place the upper handlebars on the lower handlebars aligning
WASHER
HANDLEBAR
Attaching the Grass Catcher
BRACKET
Lift the discharge flap. Hook the grass catcher bag into the lawn-
mower. Fold the discharge flap down (see Figure 3).
Inserting/Replacing the Battery
Charge the battery as described in the charger operation manual.
Open the battery cover
power tool until it clicks into place
To remove, press the release button
CURVED
HEAD BOLT
DISCHARGE
FLAP
Battery Charge Indicator
The unit has a LED battery charge indicator
on the handlebar. The LED shows 4 meaning
there is 100% battery power, 3 is 75% power,
2 is 50% power, 1 is 25% power and 0
indicates there is no power .
hex bolt through on the top and secure with a hex nut on each
side. Push a long carriage bolt through on the bottom and secure
with a washer and triangle knob (see Figure 1).
the holes in each. Insert the curved head bolt through the holes
in the upper handle, the lower handle, plastic bushing and flat
washer then secure with the triangle knob. Turn the triangle knob
to tighten securely (see Figure 2).
1
1
2
Protect the battery contacts when the battery is not being used.
Metal objects may short-circuit the contacts and pose
both an explosion and fire hazard!
. Press the charged battery into the
. Close the battery cover
2
and pull out the battery
1
3
!
CAUTION
"4" ~ 100%
"3" ~ 75%
"2" ~ 50%
"1" ~ 25%
"0" ~ 0%
.
3
.
2
2
1
7