Sony SRX-R815P Safety Regulations page 4

SAFETY WARNING TO
AVOID EYE INJURIES
For SRX-R815/SRX-R810
and for interchangeable
lenses
As with any bright light source, do not stare into the beam,
RG2 IEC 62471-5:2015.
Do not look into the beam
No direct eye exposure to the beam is
permitted
This product becomes Risk Group 3 (RG3) at use of high
throw ratio (TR) of LKRL-Z514/LKRL-Z519 lens
according to the IEC 62471-5:2015. (Photobiological
safety of lamps and Lamp system-Part 5: Image projectors)
RG3 products pose a potential hazard even for momentary
exposures at close distance and product safety
requirements are generally essential.
RG3 projectors pose a risk resulting from direct, intra-
beam viewing at close distance.
- Hazardous Area: Distance of any point of this area
from the source of the light is within the Hazard
Distance. The intensity of the light exceeds the
Maximum Permissible Exposure (M.P.E.) on the
cornea in the area. The light beam can thus be
considered as dangerous if the operator/spectator
looks into the beam directly.
- Hazard Distance values under LKRL-Z514/LKRL-
Z519 lens of this product are shown in the following
table.
Top
view
4
SAFETY WARNING TO AVOID EYE INJURIES For SRX-R815/SRX-R810 and for interchangeable lenses
Hazardous Area
Hazard Distance
See the table.
Range of
Lens type
throw ratio
LKRL-Z511 1.05 - 1.75
LKRL-Z514 1.35 - 2.34
LKRL-Z519 1.80 - 4.00
LKRL-A502 (3D) 1.03 - 2.33
LKRL-A503 (3D) 1.70 - 4.73
This product is for professional use without intention to be
used at home. Prior to use of the product, you must consult
with the dealer and the installer about safe use of the
product.
Precautions during operation, service, maintenance and
installation:
- During operation of the product, restrict human access
into the area.
- In case persons stand in the area, operate the product
and reduce the light beam, for example, by setting it
"stand-by mode".
- In case the product operates without an operator,
install the product with a sufficiently large separation
height above the floor level or use physical barriers (or
sign on the floor) in order to avoid unintentional access
of persons into the area.
Hazard distance
Not available (RG2)
TR = 1.35 - 2.20: RG2
TR = 2.21 - 2.34 : HD = 1.2 m
TR = 1.80 - 2.20: RG2
TR = 2.21 - 4.00 : HD = 1.8 m
Not available (RG2)
Not available (RG2)