Before Calling Service Personnel - LG FFH-185MVA Owner's Manual

PAGE 26 REFERENCE

Before Calling Service Personnel

Check the following guide for the possible cause of a problem before contacting service.
Symptom
• The power cord is disconnected.
No power.
No picture. • The TV is not set to receive VCD signal
output.
• The video cable is not connected
securely.
• The connected TV power is turned off.
There is no sound or • The audio cables are not connected
only a very low-level securely.
sound is heard.
• The power of the equipment connected
with the audio cable is turned off.
• The audio connecting cord is damaged.
The playback picture is poor.
• The disc is dirty.
The unit does not start • The disc is placed upside down.
playback.
• The disc is not placed within the guide.
• The disc is dirty.
• The plugs and jacks are dirty.
Severe hum or noise is
heard.
• The disc is dirty.
• The speakers and components are
connected poorly.
• The unit is located with TV nearly.
• The components are connected
Recording cannot be
incorrectly.
done.
• The source is selected incorrectly.
Radio stations cannot
• The antennas are connected poorly.
be tuned in.
• The signal strength of the stations is too
The remote control
weak (when tuning in with automatic
does not work properly.
tuning).
• The remote control is not pointed at the
remote sensor of the unit.
• The remote control is too far from the
unit.
• There is an obstacle in the path of the
remote control and the unit.
• The batteries in the remote control are
exhausted.
Symptoms and Correction
Cause Correction
• Plug the power cord into the wall outlet
securely.
• Select the appropriate video input mode
on the TV so the picture from the unit
appears on the TV screen.
• Connect the video cable into the jacks
securely.
• Turn on the TV.
• Connect the audio cable into the jacks
securely.
• Turn on the equipment connected with
the audio cable.
• Replace it with new one.
• Clean the disc.
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Wipe them with a cloth slightly moistened
with alcohol.
• Clean the disc.
• Connect the speakers and components
securely.
• Move your TV away from the audio
components.
• Connect the components correctly.
• Select the source with the FUNCTION
SELECT button (CD, AUX or TUNER).
• Connect the antenna securely.
• Adjust the antennas and connect an
external antenna if necessary.
• Tune in the station manually.
• Point the remote control at the remote
sensor of the unit.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones