Advertisement
↑ or ↓ to select "enable" or "disable". Once enable is selected, the programmer will check the status of socket continuously, and automatically start to run the command sequence once it identifies there is
For "PRODUCTION MODE" Setting, use
a chip in the socket. The
zero-key-stroke operation is enabled. The default is "enble".
2) AUTO CHECKSUM
↑ or ↓ to select "enable" or "disable". Once "enable" is selected, the programmer will verify the checksum automatically before executing RUN. The default is "enble".
For "AUTO CHECKSUM" Setting, use
3) PIN CHECK
↑ or ↓ to select "enable" or "disable". Once "enable" is selected, the programmer will execute the insertion check and the contact check before operation. The default is "enable".
For "PIN CHECK" Setting, use
4) BEEPER
↑ or ↓ to select "enable" or "disable". The default is "enable".
For "BEEPER" Setting, use
MODULE STATUS
The LCD can monitor and display operation information or status of one module only at one time. Use → ← to select the module. Only under production/asynchronous mode can the module be changed in the process of device
operation.
IV.Important Information
The project file may be changed occasionally which will cause property loss. The advice is below:
¢Run BUFFER COMPARE and CHECKSUM before production.
¢Assemble and test the sample before volume production.
SUPERPRO/9000U Menu Flowchart
SELECT FUNCTION
1) RUN
2) BUFFER
3) SETTING
4) MODULE STATUS
AT89C51
1) AUTO
2) PROGRAM
3) READ
4) VERIFY
5) BLANK CHECK
6) ERASE
7) LOCK-BIT1
8) LOCK-BIT12
8) LOCK-BIT123
BUFFER
1) DISPLAY BUFFER
DISPLAY BUFFER
00000000: 4D
2) BUFFER COMPARE
3) CHECK SUM
SETTING
1) PRODUCTION MODE
2) AUTO CHECKSUM
3) PIN CHECK
4) BEEPER
MODULE 1:
RESULT: OK
PRODUCTION MODE
1) ENABLE
2) DISABLE
AUTO CHECKSUM
1) ENABLE
2) DISABLE
PIN CHECK
1) ENABLE
2) DISABLE
BEEPER
1) ENABLE
2) DISABLE
Advertisement
