Xeltek SUPERPRO 9000U Operation Instructions

I. Introduction
SUPERPRO/9000U is a high speed universal gang programmer, which comes with the following operation modes:
1. PC-Hosted Mode (Remote Mode)
Programmer is controlled by PC via USB port.
2. Stand-Alone Mode
Powered by keyboard, LCD and large capacity Compact Flash card for algorithms and user data, SUPERPRO/9000U performs the same functions as PC-hosted mode without connecting to PC. The user can download the
project file into the CF card with connecting to PC (no function of serial number generation under stand-alone mode).
Below are instructions for stand-alone mode only. Please refer to USER'S GUIDE- SUPERPRO FOR WINDOWS for PC-hosted mode.
II. Operation Preparation
The CF card is required for both PC and stand-alone mode, in which all contents related to the operation are stored in the format of project file. The four cards should be with same capacity. The project file includes device type, data file,
device configuration file, AUTO batch command sequence etc. Project file is generated under PC mode and then downloaded to the CF card. The project file function under the stand-alone mode simplifies the operation and prevents the
loss from the operation mistakes. Only one project file can be stored. The CF card is used not only for storing the project files but also as the data buffer. The minimum capacity of CF card needed to support a device is 2 times of its
capacity. For example, a 128Mb device needs at least a 32MByte (256Mbit) CF card. Under PC mode the current operation environment is saved automatically as a temporary project file in the CF card. Any changing in buffer, device
configuration etc. will touch off a project file downloading. At the moment it is turned on again and enter in stand-alone mode it works under the same settings with the last operation under PC mode.
III. Menu
Keyboard
ENTER Select and enter the submenu
EXIT Exit to the previous menu.
↑ ↓
Scroll to select.
→ ←
Scroll to locate an address or data in buffer display; Select the module to display its status (available in production/asynchronous mode only).
RUN
Execute the sequence of programming operations. The function set varies wit h types. Standard functions are as follows:
AUTO Execute the AUTO batch command sequence.
PROGRAM Programs a chip with the buffer data.
BLANK CHECK Check whether the chip is blank or not
VERIFY Compare the programmed data with the buffer data.
ERASE Erase the chip
SECURE Protect the chip. Same with LOCK/MEMORY PROJECT
* READ function is not provided under stand-alone mode for safe of data integrity.
BUFFER
1) DISPLAY BUFFER
Display the content in the buffer. Use ENTER to display the start address and data, and → or ← to move the cursor to the address to be displayed; Use
2) BUFFER COMPARE
Compare the buffers of the 4 CF card. They should be the same.
3) CHECK SUM
Calculate the checksum of the buffer and compare with the value saved in the project file. If they are different the buffer may be changed occasionally. You should stop to check the integrity of the project file.
OPTION
Modify some options of the project. It should be noted that the change is not saved. The Initial settings will always be used. The only way to change the default settings is work under PC mode.
1) PRODUCTION MODE
®
SUPERPRO /9000U
Operation Instructions for Stand-Alone Mode
↑ or ↓ to change the address. ENTER to stepping the address.