Taking To The Installation Location - Convotherm OES 6.10 Installation Manual

Moving and setting up the appliance
►

Taking to the installation location

Space required for conveying the appliance
Make sure that there is enough width and height along the entire route used for conveying the appli-
ance to ensure it can get through to its installation location.
The table below shows the required minimum door size to allow the combi steamer to be brought to its
intended location:
Width
Height
Load bearing capacity of moving equipment
Provide moving equipment that is rated capable of carrying the load.
The table below shows the minimum load bearing capacity required of the moving equipment:
Weight OEB
Weight OES
Weight OGS
Weight OGB
The figures refer to appliances including packaging and CONVOClean system. For appliances that do
not have the CONVOClean system you can deduct 5 kg in each case.
Personal protection equipment
Wear personal protection equipment when carrying out the tasks described here:
Safety boots
Hard hat (when heavy loads are being lifted or when working overhead)
Installation manual
Table-top appliances
6.10 6.20
[mm] 1130 1410
[mm] 1002 1085
Table-top appliances
6.10 6.20
[kg] 163 230
[kg] 156 211
[kg] 163 221
[kg] 185 248
10.10 10.20
1130 1410
1270 1290
10.10 10.20
192 270
180 255
188 272
210 297
35
Floor-standing appliances
12.20 20.10
1435 1150
1596 2132
Floor-standing appliances
12.20 20.10
350 357
335 329
344 355
380 399
20.20
1435
2138
20.20
455
433
467
510