Figure 1 - Dip Switches - Sierra Wireless Uplink 5500EZ Installation And User Manual

Installation and User Guide
5. Disconnect the unit from the power supply before wiring. The standard
configuration for the Uplink 5500EZ is to leave DIP switches S1 and S2 set to
"OFF" (Input 1 triggered by 9V DC to 12V DC or an open collector). For detailed
wiring instructions and alternative configurations, see UNIT WIRING on pages
8 and 9.
Do not connect the unit to a receptacle controlled by a switch.
Caution:
Improper connections at the power connector may result in damage to the unit.
Caution:
6. Configure the unit. Set the DIP switches on the front panel of the unit according
to the following table:

Figure 1 - DIP SWITCHES

DIP Switch Settings
4 1 3 4 6 4 7
Table 2: Dip Switch Settings
S1
OFF
S1 and S2 OFF
ON
ON
OFF
S3
ON
OFF
S4
ON
R e v 2
S2 Input 1 Type
OFF Standard Input
ON Pulse Counter
OFF Timed Bell
ON Sampled Siren
Input 4 Normal Operation
Input 4 Neg Pulse causes reset
Output 1 - Controllable via Website
Output 1 - Normally Closed Trouble Output
Se pt e m be r 1 2 , 2 0 1 8
Installation
1 2