Table of Contents
Advertisement
5.
Slide the carrier frame with CPU into the
rail frame, then remove the PnP cap.
The carrier frame with CPU fits in only
one correct orientation. DO NOT force
the carrier frame with CPU into the
rail frame.
6.
Gently push the rail frame just enough
to let it sit on top of the CPU socket.
7.
Close the load plate just enough to let
it sit on top of the CPU, then secure
each screw one by one in the sequence
shown on the socket to completely
secure the load plate.
The load plate screws are T20
models. A torque value of 12 inch-lbf
is recommended.
2-8
Carrier frame
with CPU
Rail frame
PnP cap
Carrier frame
with CPU
Chapter 2: Hardware Information
Advertisement
Table of Contents
