Starting The Service Software; Before The First Run Of The Service Software Program; Figure 7: Entry In The "Properties" Window Of A Service Software Tool - IRIS IRMA MATRIX Operating Instructions Manual

13/15 Starting IRMA MATRIX on the PC via Ethernet
released
7

Starting the service software

7.1

Before the first run of the service software program

In order to prevent communication problems, the communication path is determined for
all service software variants. Before the first run of a service software tool please proceed
as follows:
1. Mark the program icon on the desktop, right-click and select "Properties". The
2. Click into the input window "Target", see Figure 6.
3. Directly behind "DIST500-Configuration.exe" enter the following string:
4. Click "OK" to save the entry.
Figure 6: Entry in the "Properties" window of a service software tool
Rev. 1.2 2016-02
"Properties ..." windows opens.
[1 x space]-ipaddr=10.0.0.55
The characters "10.0.0.55" must correspond to the address which had before been
entered as the IP address for the PC (see section 4.1 on page 7).