TUCSON XL PATIO AWNING Installation Manual 1109 1 INTRODUCTION ........................3 Symbols used in this manual ........................3 Personnel requirements ..........................3 Required equipment ..........................3 Contents of packaging ..........................4 2 SAFETY ..........................4 General safety information ........................4 Requirements for working in safety ......................
TUCSON XL PATIO AWNING Installation Manual 1109 1 INTRODUCTION This manual was prepared by the Manufacturer to provide the necessary information to those authorized to install and perform special maintenance on the product. It is prohibited to remove, rewrite or in any way modify the pages of the manual and their content.
TUCSON XL PATIO AWNING Installation Manual 1109 1.4 - Contents of packaging The awning is delivered complete with arms, fabric, control (manual or motorized) and any requested optional. INFORMATION AND PRECAUTIONS Never move the arm supports from the position in which they are supplied.
THE FOLLOWING TABLES ARE PURELY INDICATIVE. TO THE BEST OF OUR KNOWLEDGE THE INFORMATION IS UP TO DATE SW SUN CONTROL DOES NOT PROVIDE ANY GUARANTEE REGARDING ACCURACY, RELIABILITY, AND COMPLETENESS OF THE INFORMATION CONTAINED HEREIN. INDEED, IT IS THE USER’S RESPONSIBILITY TO ENSURE THE SUITABILITY AND CORRECTNESS OF THIS INFORMATION.
Page 6
TUCSON XL PATIO AWNING Installation Manual 1109 INFORMATION AND PRECAUTIONS Determine the center point of the overall width of the square bar for proper component placement. Component placement goes from square bar edge to center and is mirrored on both sides of awning when table calls for even number of components.
TUCSON XL PATIO AWNING Installation Manual 1109 3.4 - Exploded View of Tucson XL Components 7:1 gear Runners for “Tucson XL” arms Hand brace Front bar Wall brackets Front bar end covers Ceiling brackets Hood Square bar End covers for hood...
TUCSON XL PATIO AWNING Installation Manual 1109 4 INSTALLATION OF MANUAL AWNING The instructions below refer to wall mounting; ceiling mounting is the same. If any options are in use, first read Chapter 6 "Optionals" WARNING Ensure a minimum space of 19.75 inches between the open awning and any fixed obstacle.
TUCSON XL PATIO AWNING Installation Manual 1109 INFORMATION AND PRECAUTIONS If the wall is off-square, it may difficult to install the awning on the wall brackets. It is therefore advisable to check the alignment of the mounting brackets and to provide inserts to ensure proper alignment for good installation.
TUCSON XL PATIO AWNING Installation Manual 1109 4.3 - Adjustment of Awning Inclination INFORMATION AND PRECAUTIONS The instructions that follow are of a general nature and must therefore be adapted to the model of awning being assembled. For this procedure, one worker will need to work on...
TUCSON XL PATIO AWNING Installation Manual 1109 5 INSTALLATION OF MOTORIZED AWNING The instructions below refer to wall mounting; ceiling mounting is the same. If any options are in use, first read Chapter 6 "Optionals" WARNING IT IS PROHIBITED to install the motorized product in an explosive atmosphere.
TUCSON XL PATIO AWNING Installation Manual 1109 7 SPECIAL MAINTENANCE 7.1 - Troubleshooting table MANUAL AWNING PROBLEMS CAUSES SOLUTIONS The fabric does not roll up straight Incorrect symmetry of arms See manual for Assembly, Chap. 7 Uneven fabric Roll the fabric all the way back up...
Need help?
Do you have a question about the TUCSON XL PATIO AWNING and is the answer not in the manual?
Questions and answers