Group; Display Status; Help - 3Com EtherLink 10/100 PCI NIC Series User Manual

38 C 4: I
HAPTER NSTALLING AND
C N W
ONFIGURING IN ET ARE

group

This command creates groups from specified slot parameters for primary and
secondary NICs.
Syntax lbrsl group lb addr RxIPAddr pri_slot sec_slot [sec_slot ...]
lbrsl group rsl pri_slot sec_slot [sec_slot...]
where:
lb specifies a load balancing group.
rsl specifies a resilient server link group.
RxIPAddr is a dedicated IP address for the load balancing group
pri_slot is the PCI slot number of the primary NIC.
sec_slot is the PCI slot number of a secondary NIC.
Example lbrsl group lb addr 192.1.1.100 10001 10002
lbrsl group rsl 10001 10002
Default None

display status

This command displays information about all groups, or if a primary slot parameter
is specified, about only the specified group. A separate message is displayed for
each loaded frame type. Board numbers are also displayed. Information about the
relationship between the board numbers and the frame types is shown in the
NetWare 5 Console Monitor. On the Available Options screen, select LAN/WAN
drivers for this information.
Syntax lbrsl display status [pri_slot]
where:
pri_slot is the PCI slot number of the primary NIC in the group for which
information is to be displayed. If this parameter is not specified, information for all
groups is displayed. An example of the type of information displayed follows:
Group NNN (LB group)
Primary board id: Original NNN, Current NNN
Load balancing on incoming IP packets: Enabled; IP Rx Addr: NN.NN.NN.NN
Primary node address: XX:XX:XX:XX:XX:XX
Timeout values in seconds: send NNN, receive NNN, wait NNN, link NNN
Probe Interval: NNN seconds
Slot number NNN (Active), Node Address: XXX:XXX:XXX:XXX:XXX:XXX
Example lbrsl display status 10001

help

This command displays the syntax for the DynamicAccess server features
commands.
Syntax lbrsl help