Connection To The Gas Supply - Technika TEG95DUA Instructions For Use And Installation

Installation

Connection to the gas supply

For ease of service, the cooker should be
Flexible Hose, which complies with AS/NZS 1869 (AGA Approved),
10mm ID, class B or D, between 1 - 1.2m long and in accordance
with AS5601 for a high level connection.
WARNING: Ensure that the hose is not subjected to abrasion,
kinking or permanent deformation and should be able to be
inspected along its entire length. Unions compatible with the hose
fittings must be used and connections tested for gas leaks. The
fixed consumer piping outlet should be at approximately the same
height as the cooker connection point, pointing downwards and
approximately 200mm - 300mm in from the left hand side of the
cooker. The hose should be clear of the floor when the cooker is in
the installed position. A hose restraint chain should be anchored to
the wall to prevent strain on the hose connections when the cooker
is pulled forward.
Fit the supplied Gas Inlet Elbow (C) and Gasket
(B) to the Gas Inlet Fitting (A) as shown in the
illustration on the right. The gas inlet elbow has
a 1/2" BSP male thread. When making the
connection, take care not to apply excessive
stress by counterbalancing tightening force.
Ensure that the available gas supply is the same
as the gas type label affixed near the gas
connection point. If not, contact Technika for a
Gas Conversion Kit.
Natural Gas
The natural gas regulator supplied must be fitted for natural gas.
Ensure the arrow on the regulator points towards the direction of
the gas flow. The test point pressure must be adjusted to 1.00 kPa
with the largest burner operating on maximum flame.
U-LPG
Fit the Universal LPG test point assembly (supplied in the gas
conversion kit). An AGA Approved gas regulator suitable for a
supply pressure of 2.75kPa should be part of the gas tank supply.
connected with a
A
B
C
A - Manifold Nut
B - Gasket
C - Elbow
34