Advertisement
MOUNTING INSTRUCTIONS
19
Tighten seal head to 30 Nm and remove seal
head tool.
20
Make sure that shaft assembly and outer tube
are in their bottom positions.
Set suspension fluid level according to chapter
"Setup Data".
21
Install tool on shaft extension.
Install preload tube (A), main spring (B) and
spring support (C) over shaft extension
tool. Select main spring according to chapter
"Main spring guide".
[01765-03 shaft extension tool]
22
Pull up shaft assembly and grab spring support
with a wrench.
[ rench 19 mm]
23
Remove shaft extension tool.
24
Make sure that compression and rebound
adjusters are fully open before installing top
cap. Use a hex key to open compression and
rebound adjusters.
[Hex key 3 mm]
25
Install o-ring on top cap. Apply grease on o-ring
and thread.
[00576-02 o-ring]
[00146-01 grease]
26
Install top cap on shaft extension. Tighten to
20 Nm.
[Socket 14 mm]
27
Remove wrench from spring support.
28
Pull up outer tube. Make sure front fork leg is
in a fully extended position. Use top cap tool to
tighten top cap to outer tube. Tighten to 10 Nm.
[00797-08 top cap tool]
29
Set compression, rebound and main spring
adjusters according to chapter "Setup Data".
Use a hex key for compression and rebound
adjusters. Use a socket for main spring preload
adjuster.
[Hex key 3 mm]
[Socket 14 mm]
30
Install front fork legs in vehicle at
recommended front fork leg position, according
to chapter "Setup data".
31
Remaining installation, instructions according
to vehicle service manual.
21
22
C
B
A
26
7
Advertisement
