Update & Configuration - Technomate TM-RF HD IR User Manual

7.c. Connecting an aerial system
If you have a UHF TV aerial, you can connect this to the RF IN.
The RF OUT will then combine video/audio of the source with your TV signal, so that when you do an automatic digital
scan on your TV, it will find the TM-RF HD IR channel as well as all your TV channels.
If some aerial channels have an issue, such as distortion, the current dB may be too high. Please decrease the dB in:
Menu – Advanced – dB Level.
7.b. Defining Channel Numbers in your TV's channel list
If your TV supports LCN, the TM-RF HD IR will appear in your TV's channel list as the channel number you selected. The
default is 800 which means the TM-RF HD IR will appear as channel 800 in your EPG of your TV after all your TV / Radio
channels.
You will need to check which LCN numbers are free in your EPG to allocate a different number.
If after a search, the channel appears at a different number, this means that the LCN number you chose is not available
or that your TV does not support LCN.
If you are not using an aerial/antenna, then the LCN can be set to 1 to appear as Channel 1 in your EPG and TV.
Please also check that LCN in your TV is ON as it may be defaulted to OFF.
8. UPDATE & CONFIGURATION
1. To update to the latest software
a. Copy the TM-RF HD IR software file to the root directory of your USB drive (FAT32 format).
b. Turn the power of the TM-RF HD IR OFF.
c. Connect the USB to the USB Service Port.
d. Turn the power ON.
e. The file will automatically install within a few seconds.
f. Remove the USB after the TM-RF HD IR has finished booting up.
2. To update to the Cascaded Settings
a. Connect a USB drive (FAT32 format) to the USB Service Port.
b. Go to System - Upload.
c. Use Notepad on a PC to open and edit the file.
d. Each file should have unique settings only for the following information:
i.
ii.
iii.
iv.
v.
8
Channel Number
Service Name
Service ID
Provider Name
LCN ID