Welding The Bracket - Air Weigh LoadMaxx Installation Manual

Welding the Bracket

1. Place the bracket assembly on the suspension. Make sure
the bare metal you sanded earlier lines up with the large
holes in the brackets.
2. Using two C-clamps, secure the bracket assembly to the
suspension (Fig. 12)
3. Using a MIG or ARC welder, tack-weld the two large holes
(top, bottom, left, right).
4. Then plug-weld the circumference of the two large holes in
the bracket assemblies ONLY.
5. Once the welds are COMPLETELY cooled, remove the
clamps.
6. Using enamel spray paint, paint all welded and sanded areas
to prevent oxidization.
7. Remove the two bolts from the bracket assembly and
remove the assembly jig.
Fig. 12: Clamping the bracket assembly to the suspension
13