Operation Setting - DENRYO PANcharge1k User Manual

3-4. Operation Setting

Step 1. Make sure the AC power voltage switch is setting correctly.
Step 2. Make sure nothing is connecting to charging clips.
Step 3. Set 115 when input 90-120Vac; set 230 when input 180-240Vac.
WARNING
Step 4. Press I on the AC power switch to turn charger on.
Step 5. All LED indicators light for 2 seconds. Afterward, red LED flashes indicate the charging clips
is disconnecting to battery. The rectangle LED indicates the set charging voltage.
Step 6. Set charging voltage by pressing the switch key around 0.5 seconds. The setting order is
12V → 24V → 36V → 48V →12V.... The number of rectangle LED lights reflects to the
charging voltage user chose.
NOTE
Step 6. Press O on the AC power switch to turn charge off. The setting is done.
115Vac
The AC power voltage setting must to be set as same as the input voltage.
Never input 230Vac under the setting of 115Vac.
12V
36V
The charging voltage must to be set as same as the battery voltage.
Input voltage
Setting
Setting
LED status
Setting
LED status
9
230Vac
24V
48V