Advertisement
2.
Using isopropyl alcohol on a shop towel, clean the
four brackets B where the small pads will attach.
Remove the adhesive backing from the small
pads, and attach them to brackets B.
SMALL PAD
ATTACHING
SURFACE
LARGE PAD
ATTACHING
SURFACE
3.
Using isopropyl alcohol on a shop towel, clean the
four plates where the large pads will attach.
Remove the adhesive backing from the large pads
and attach them to the plates.
2 of 4
SMALL PAD
ADHESIVE
BACKING
BRACKET B
LARGE PAD
ADHESIVE
BACKING
PLATE
AII 28621 (0502)
4.
Under the roof box, insert a bolt through bracket
B, through the plate and into the predrilled hole in
the bottom of the roof box.
STRAP EYELET
(Position the holes
equally on both
sides.)
KNOB
WASHER
BRACKET A
PLATE
BRACKET B
CUTOUT
BOLT
(Faces the
outboard side.)
5.
Fit bracket A over the threads of the bolt where it
protrudes through the roof box. Install a washer
over the threads, and loosely install a knob. Install
a second bolt the same way.
•
Install bracket B with the cutout facing the
outboard side.
6.
Repeat steps 4 and 5 to install the brackets in the
other three positions.
•
Install brackets A so the strap eyelets on the
left and right sides of the box are directly
across from each other.
©
2005 American Honda Motor Co., Inc. - All Rights Reserved.
ROOF BOX
STRAP EYELET
(Position the
holes equally on
both sides.)
KNOB
WASHER
BRACKET A
PLATE
BOLT
CUTOUT
BRACKET B
(Face the
outboard side.)
Advertisement
