Advertisement
With Fog Lights
If the vehicle you are working on is equipped with fog
lights, cut out the piece of the bumper section that
covers the fog lights:
•
Face the inside of the mask toward you.
•
Carefully cut out the fog lights section with
scissors at the top seam, and remove the red
overcast stitching.
RED OVERCAST STITCHING
(Remove for fog lights.)
BUMPER MASK
Installing the Hood Section
1.
Open the hood, fit the corners of the hood
section around the hood, and adjust the mask so
it fits smoothly over the edges. Attach the three
hooks to the holes in the hood.
HOOD
MASK
2 of 4
HOOK
HOOK
HOOD
Installing the Bumper Section
2.
Turn the steering wheel all the way clockwise.
3.
Pry out the plastic pin, and remove the expansion
clip that fastens the inner fender; retain the clip.
Clean the area around the hole.
4521010K
4.
Pull the inner fender back, and press one
fenderwell nut (supplied) into the hole in the fender
flange.
5.
With its washer in place, securely tighten one
snap-screw into the fenderwell nut.
6.
Turn the steering wheel all the way
counterclockwise, and repeat steps 3 through 5
on the other side of the vehicle.
4521020K
AII 28606 (0502)
INNER
FENDER
EXPANSION
WASHER
CLIP
FENDERWELL NUT
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
SNAP
SCREW
4521030K
Advertisement
