Information; Input Source Information Display - Sanyo PLV-Z4000 Owner's Manual

Information

Input Source Information Display

The Information Menu is used for checking the status of the image signal being projected and the operation of the projector.
Direct Operation
Press the INFO. button on the top control or on the remote control
to display the Information Menu.
Menu Operation
Press the Point buttons to select the Information Menu. The
ed
Information Menu is displayed.
See below for displayed information.
Input
The selected input source is displayed.
Signal
Video or S-video
Component
HDMI
PC
No signal
Out of recognition
H-sync freq .
The horizontal frequency of the input signal is displayed in KHz, or
"- - - - -" when no signal.
V-sync freq .
The vertical frequency of the input signal is displayed in Hz, or "- - - - -"
when no signal. Numbers of Hz doubles when during Interlace.
Deep color
The deepness of the color in HDMI input signal is displayed, or "- - - - -" when
8 bit signal.
Image
The selected image mode is displayed.
Screen
The selected screen size is displayed.
Lamp status
The selected lamp mode is displayed.
Lamp time
The cumulative lamp operating time is displayed.
Filter time
The cumulative filter operating time is displayed.
A color system of the connected video
signal is displayed from among PAL,
SECAM, NTSC, NTSC4.43, PAL-M, and
PAL -N.
A system mode of the connected video
signal is displayed from among 480i, 480p,
575i, 575p, 720p, 1080i and 1080p.
A system mode of the connected video
signal is displayed from among D-VGA, D-
WXGA, D-480i, D-480p, D-575i, D-575p,
D-720p, D-1080i, and D-1080p.
A resolution of the connected computer
signal is displayed.
When there is no signal input, "- - - - -" is
displayed.
When the connected input source is out of
recognition, "Unknown" is displayed.
Top Control
Remote Control
Information Menu
INFO . button
INFO . button
43