Basic Operation
SHUTTER button
See page 27 for details.
FILTER button
Press and hold the FILTER button for more than five
seconds to replace the filter mechanically.
✔
Note:
•
The filter cannot be rewound.
• When the filter is replaced, the total accumulated time of
the filter use is automatically set to 0.
IMAGE ADj . button
Press the IMAGE ADJ. button on the remote control to
adjust a image level of the screen.
For more detail, see pp.45-47 .
IMAGE SEL . button
Press the IMAGE SEL. button on the remote control to
select a desired image level of the screen.
For more detail, see pp.38, 42.
P-TIMER button
Press the P-TIMER button on the remote control. The
Timer display "00 : 00" appears on the screen and starts
to count time (00 : 00–59 : 59).
To stop the P-TIMER, press the P-TIMER button.
To cancel the P-TIMER, press the P-TIMER button again.
KEySTONE button
Press the KEYSTONE button on the remote control. The
"Keystone" appears on the screen.
Use the Point ed7 8 buttons to correct keystone
distortion. The keystone adjustment can be stored
(pp.40, 44).
Reduce the upper width with
Point
button.
e
0
Reduce the lower width
with Point
button.
d
Remote Control
P-TIMER
button
✔
Note:
•See the previous page for the description of
other buttons.
P-Timer display
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control again while the Keystone dialog box is being
displayed, the keystone adjustment will be canceled.
• The adjustable range can be limited depending on the
input signal.
• "Keystone" disappears after 10 seconds.
Reduce the left part with
Point
button.
7
SHUTTER
button
IMAGE ADj .
button
KEySTONE
button
IMAGE SEL .
button
FILTER
button
Reduce the right part with
Point
button.
8